Cannot Undock Window in Visual Basic with ClickSaver Feature

 Last reviewed: October 31, 1997
Article ID: Q176044
The information in this article applies to:
  • Microsoft IntelliPoint software versions 2.0, 2.0a, 2.1

SYMPTOMS

When you click a docked window in Microsoft Visual Basic 5.0 with the ClickSaver feature enabled in the Mouse tool in Control Panel, the window may not undock.

RESOLUTION

To resolve this issue, double-click the docked window.

If this does not undock the window, turn off the ClickSaver feature by following these steps:

  1. Click Start, point to Settings, and then click Control Panel.

  2. Double-click Mouse.

  3. On the StepSavers tab, click the ClickSaver check box to clear it.

  4. Click OK.

STATUS

Microsoft is researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.

MORE INFORMATION

You can use the ClickSaver feature to click once where you normally double- click.

When you click an undocked window once in Visual Basic 5.0 with the ClickSaver feature enabled, the window docks correctly.

Additional query words: vb vba 2.10 2.00 2.00a
Keywords : intellipoint kbtool kbui
Version : WINDOWS:2.0,2.0a,2.1
Platform : WINDOWS

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 31, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.