Interrupt Setting for the IBM PS/2 Model 30

Last reviewed: September 16, 1996
Article ID: Q28497
The information in this article applies to:
  • Microsoft InPort Mouse, version 1.x
  • Microsoft Mouse Driver for MS-DOS, versions 6.x, 7.x, and 8.x

SUMMARY

When you install the mouse InPort interface card on a PS/2 Model 30, Microsoft recommends that you set the J4 interrupt to jumper 2 or 3.

Please check that other peripheral boards are not using the same interrupt setting as the mouse. Do not use pair 5 for the setting.

The IBM product included here is manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.


KBCategory: kbsetup kbhw kb3rdparty
KBSubcategory:
Additional reference words: 8.10 8.00 setup install 3rdparty


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 16, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.