AT&T 6300 Plus and Bus Mouse

Last reviewed: September 16, 1996
Article ID: Q32682

The information in this article applies to:

Microsoft Mouse Driver for MS-DOS, versions 6.x, 7.x, 8.x, and 9.0

SUMMARY

If you use the Microsoft bus mouse with the AT&T 6300 Plus, set the J4 jumper to either 3 or 4.

Although interrupt 5 should be a free interrupt on an AT computer, there have been problems reported while using interrupt 5 with this computer. These problems may occur with any program that uses the mouse; however, the problem has not occurred with Paintbrush, CPANEL.COM, and DEFAULT.COM.

The product included here is manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.

KBCategory: kbhw kb3rdparty
KBSubcategory:
Additional reference words: A T & T 3rdparty

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 16, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.