Bus Mouse with InPort Not Supported in IBM PC-DOS 4.00

Last reviewed: September 16, 1996
Article ID: Q35364
The information in this article applies to:
  • Microsoft Mouse Driver for MS-DOS, versions 6.x, 7.x, and 8.x

SUMMARY

IBM PC-DOS Version 4.00 has three special mouse drivers that only work with the DOS Shell: PS/2, serial, and bus mouse (non-InPort).

For bus mice with InPort, we recommend that you load the mouse driver that was included with your mouse (MOUSE.COM) and delete the following command line in the DOSSHELL.BAT that loads the IBM DOS shell mouse driver:

   /MOS:PCMSPDRV.MOS


KBCategory: kbhw kbtool
KBSubcategory:
Additional reference words: mice pc ps/1 ps/2 8.00 8.10 8.20



THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 16, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.