Pinouts of the 9-Pin Inport and Bus Mouse Hosiden Socket

Last reviewed: September 16, 1996
Article ID: Q61593
The information in this article applies to:
  • Microsoft Mouse Driver for MS-DOS, versions 6.x, 7.x, and 8.x

SUMMARY

The following is the signal configuration of the 9-pin Hosiden socket on the bus adapter of the Microsoft Mouse:

   Pin        Signal
   ---        ------

   1          +5v
   2          XA
   3          XB
   4          YA
   5          YB
   6          SW1
   7          SW2
   8          SW3
   9          Signal ground
   E          Shield ground


KBCategory: kbhw
KBSubcategory:
Additional reference words: pinout pin-outs pins


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 16, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.