CADKEY Requires Microsoft Mouse Driver Version 7.04 or Later

Last reviewed: September 16, 1996
Article ID: Q68930

The information in this article applies to:

Microsoft Mouse Driver for MS-DOS, versions 6.x, 7.x, 8.x and 9.0

The CAD software packages CADKEY and CADKEY Light require Microsoft Mouse driver version 7.04 or later to run properly. Versions of the driver earlier than version 7.04 do not allow you to operate the mouse correctly with CADKEY. In one instance, such as when using driver version 7.0, the cursor is confined to a small area of the upper-left corner of the screen.

The products included here are manufactured by CADKEY, Inc., a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.

KBCategory: kbhw kb3rdparty
KBSubcategory:
Additional reference words: AutoCAD EasyCAD FastCAD VersaCAD

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 16, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.