NEC Mouse Port, Lotus 3.1, and Microsoft Serial Mouse

 Last reviewed: September 16, 1996
Article ID: Q68959
The information in this article applies to:
  • Microsoft Mouse Driver for MS-DOS, versions 6.x, 7.x, 8.x, and 9.0

SYMPTOMS

The mouse cursor may stop responding (hang) if you use the Microsoft Mouse in the PS/2 mouse port of some of the NEC 286 and 386 machines while running the WYSIWYG mode of Lotus 1-2-3 version 3.1.

MORE INFORMATION

Contact NEC technical support at for more information.

The products included here are manufactured by vendors independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.

KBCategory: kbhw kb3rdparty
KBSubcategory:
Additional reference words: hardware ncr ibm 8.x 9.00 3rdparty

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 16, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.