The information in this article applies to:
- Microsoft BallPoint Mouse, version 1.0
- Microsoft Mouse Driver for MS-DOS, versions 8.x, 9.0
- Microsoft Mouse Driver for Windows, version 9.0
- Microsoft Windows operating system versions 3.0, 3.00a, 3.1, 3.11
SUMMARY
Installing a BallPoint Mouse for MS-DOS and Windows modifies the
AUTOEXEC.BAT and Windows 3.0 SYSTEM.INI files, as well as create a new
program group in Windows.
MORE INFORMATION
To have Windows load the original MOUSE.DRV, do the following:
- In the AUTOEXEC.BAT file, remove the following line:
set mouse=c:\ballpt
- In the [boot] section of the SYSTEM.INI file, change the line
mouse.drv=
to
mouse.drv=mouse.drv
If the BallPoint Mouse was attached to a PS/2 style port when
installed, look for the [386Enh] section in SYSTEM.INI.
Change the line
keyboard=
to
keyboard=*vkd
- From the MS-DOS prompt of the Windows subdirectory, type "setup"
(without the quotation marks). Make sure that the "Mouse:" line
reflects the type of mouse that was attached before the BallPoint
Mouse.
- To remove the newly added BallPoint Mouse Windows group,
delete each icon inside the group, then delete the group.
|