TUTORIAL.EXE Error Message: "Undefined Variable at Line 21"

Last reviewed: September 16, 1996
Article ID: Q96008
The information in this article applies to:
  • Microsoft Ballpoint Mouse, versions 1.0 and 2.0
  • Microsoft Mouse Driver for MS-DOS, versions 8.2 and 9.0

If you run TUTORIAL.EXE from the MS-DOS command line, the following error occurs:

   Undefined Variable at line 21
   Press any key to continue.

TUTORIAL.EXE was not designed to be used as a stand-alone utility. To use the tutorial, run ORIENT.EXE from the MS-DOS command line and choose TUTORIAL from the main menu.

The Microsoft BallPoint tutorial is included with the Microsoft BallPoint Mouse installation disk. It is designed to introduce the features of the Microsoft BallPoint Mouse, Control Panel, and basic BallPoint techniques.


KBCategory: kbhw kberrmsg
KBSubcategory:
Additional reference words: 8.20 8.20a ballpt mouse ball point 9.00 1.00
2.00


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 16, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.