DOCERR: Commands Not Supported by Visual FoxPro ODBC Driver

Last reviewed: September 9, 1996
Article ID: Q150505

The information in this article applies to:

Microsoft Visual FoxPro ODBC Driver version 1.0

SUMMARY

The Visual FoxPro ODBC driver Help file (Drvvfp.hlp) lists all the commands supported by the driver. However, the ODBC driver does not support all of the documented commands.

MORE INFORMATION

The following Visual FoxPro commands are incorrectly listed as supported by the Visual FoxPro driver:

   APPEND FROM
   APPEND MEMO
   DECLARE - DLL
   ERROR Command
   GETCP()
   GETEXPR()
   MESSAGE()
   ON KEY   Interface command
   PAD()    Interface Function
   REMOVE TABLE
   CLOSE DATA
   REFRESH()
   REQUERY()
   SET CARRY
   SET DEFAULT
   SET FIELDS TO
   SET PROC TO
   UPDATE ON
   CREATE DATA

Calling these commands in a trigger results in the following error messages:

   Connectivity error: [Microsoft][ODBC Visual FoxPro Driver]Unsupported
   command in rule or trigger

   -or-

   Connectivity error: [Microsoft][ODBC Visual FoxPro Driver]Unsupported
   function in rule or trigger

Additional reference words: 1.00 VFoxWin
KBCategory: kbref kbdocerr
KBSubcategory: FxotherDochelp

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 9, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.