X400: Err Msg: ERROR 3 (Network): X.25 Receive Failed...

Last reviewed: October 20, 1997
Article ID: Q101683
3.20 MS-DOS kb3rdparty kberrmsg kbtlc

The information in this article applies to:

  • Microsoft Mail Gateway to X.400, version 3.2

SYMPTOMS

Microsoft Mail Gateway to X.400 may generate this network error message:

   ERROR 3 (Network): X.25 receive failed on connection x:

CAUSE

An error occurred while the gateway was receiving a Protocol Data Unit (PDU) through X.25. The gateway or the remote MTA will try again.

This error occurs if the X.25 connection is broken while the X.400 gateway MTA is receiving a message. If the disconnection occurs before the complete message is received, the partially received message is deleted. It is up to the sending MTA to send the entire message again.


Additional reference words: 3.20 errmsg alert
KBCategory: kb3rdparty kberrmsg kbtlc
KBSubcategory: MailGWX400


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 20, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.