PROFS: Maximum Mailbag Size Reads 00000000 on Host Access

 Last reviewed: October 20, 1997
Article ID: Q103854
3.20 3.30 3.40 MS-DOS kb3rdparty

The information in this article applies to:

  • Microsoft Mail Gateway to IBM PROFS and OfficeVision, versions 3.2, 3.3, and 3.4

SYMPTOMS

Once you have properly uploaded and configured the Host Access component of versions 3.2, 3.3, and 3.4 of the Microsoft Mail Gateway to PROFS, you must log on the MSGATE ID again to allow certain files and parameters to be properly initialized.

The ID comes up as normal, but you receive this header message: 

   Maximum mailbag size (bytes) that can currently be processed: 00000000

CAUSE

If you IPL the ID without first logging off, the Host Access component is not properly initialized.

RESOLUTION

Correctly log off the VM ID, and then log back on. This allows the files and parameters to initialize properly.

Additional reference words: 3.20 3.30 3.40
KBCategory: kb3rdparty
KBSubcategory: MailGWPROFS

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 20, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.