X400: Gateway Requires P2 Originator Info for Display

Last reviewed: October 20, 1997
Article ID: Q107103
3.00 3.20 MS-DOS kb3rdparty

The information in this article applies to:

  • Microsoft Mail Gateway to X.400, versions 3.0, 3.2

For display purposes, Microsoft Mail Gateway to X.400 gets the message originator's name from the P2 of the X.400 message. If the originator field is not included in the P2 then the Gateway cannot display the message originator to you.

The X.400 implementation functions this way for two reasons:

  • The NIST Stable Implementor Agreements require all NIST-compliant implementations, supporting P2, to generate the P2 originator.
  • OSTC requires the same of OSTC-compliant implementations for Europe and Australia.


Additional reference words: 3.00 3.20
KBCategory: kb3rdparty
KBSubcategory: MailGWX400


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 20, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.