PROFS: Using the CMS TAG FILE Command

Last reviewed: October 20, 1997
Article ID: Q111950

3.20 3.30 3.40 MS-DOS kb3rdparty

The information in this article applies to:

Microsoft Mail Gateway to IBM PROFS and OfficeVision, versions 3.2, 3.3, and 3.4

The tag in CMS is the location where the destination USER and NODE information are held. By using the TAG FILE command, this information can be inserted into an empty tag. (Tag information is the Destination information associated with a particular CMS message or file, for example, destination USER and NODE).

Usually this process is used when testing the response of Host Access for mail addressed to a particular NODE or USER. The command line is:

   TAG FILE rdr_number NEW_NODE NEW_USER

where NEW_NODE and NEW_USER are the respective Node and User information the Tag the file with.

NOTE: The rdr_number is obtained by typing Q RDR ALL at the CMS prompt.

Additional reference words: 3.20 3.30 3.40
KBCategory: kb3rdparty
KBSubcategory: MailGWPROFS

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 20, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.