X400: 3.2 Setup and Maintenance Utilities

Last reviewed: October 20, 1997
Article ID: Q113827
3.20 MS-DOS kb3rdparty kbsetup

The information in this article applies to:

  • Microsoft Mail Gateway to X.400, version 3.2

SUMMARY

Version 3.2 of Microsoft Mail Gateway to X.400 has different areas for setup and maintenance. When you have installed the X.400 Gateway, use these three programs to set it up and operate it:

  • X.400 Gateway Administrator

    This program sets up the X.400 Gateway. It is described in the "Microsoft X.400 Gateway Administrator's Guide" in chapter 5 (Using the X.400 Gateway Administrator Program) chapter 6 (Setting Up the Gateway) and chapter 8 (Operating and Administering the Gateway).

  • X400GATE

    This program runs the Gateway. It is described in the "Microsoft X.400 Gateway Administrator's Guide," chapter 8 (Operating and Administering the Gateway).

  • Microsoft Mail Administrator

    This program sets up each postoffice for Microsoft Mail. Use it for the procedures described in the "Microsoft X.400 Gateway Administrator's Guide," chapter 7 (Maintaining X.400 Addresses and Backbone Connections). For more information about this program, see the "Microsoft Mail Administrator's Guide."

MORE INFORMATION

The X.400 Gateway Administrator and X400GATE programs are part of the Microsoft Mail Gateway to X.400 and are installed on the gateway postoffice. The Microsoft Mail Administrator program and Microsoft Mail External program are installed when you install Microsoft Mail.

You can run the X400GATE program only from the Gateway PC. You can run the X.400 Gateway Administrator program from any PC on the LAN that has access to the gateway postoffice.

Here is when to use each program:

Task                                   Program

Set up backbone connections            Microsoft Mail Administrator
Define the local MTA                   X.400 Gateway Administrator
Define remote MTAs                     X.400 Gateway Administrator
Route the mail                         X.400 Gateway Administrator
Set up address conversion strings      X.400 Gateway Administrator
Set up customized address mapping      X.400 Gateway Administrator
Set up X.400 profile                   X.400 Gateway Administrator
Specify gateway parameters             X.400 Gateway Administrator
Map bodyparts                          X.400 Gateway Administrator
Set the schedule                       X.400 Gateway Administrator
Print the configuration report         X.400 Gateway Administrator
Maintain the X.400 Address List        Microsoft Mail Administrator
Maintain the Postoffice Address List   Microsoft Mail Administrator
Run the gateway                        X400GATE
View and print a log file              X.400 Gateway Administrator
Return mail                            Microsoft Mail Administrator
Delete mail                            Microsoft Mail Administrator


Additional reference words: 3.20
KBCategory: kb3rdparty kbsetup
KBSubcategory: MailGWX400


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 20, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.