X400: CANCEL Does Not Save Remote MTA Screen Update Changes

Last reviewed: October 20, 1997
Article ID: Q115351
3.20 MS-DOS kb3rdparty

The information in this article applies to:

  • Microsoft Mail Gateway to X.400, version 3.2

SUMMARY

If you exit the screen using CANCEL, the Remote MTA screen does not save the changes you make using Update.

MORE INFORMATION

Although you may feel this feature does not work as expected, it actually does work as designed: Cancel takes you back to where you were before you entered the form.

All Cancel buttons in the utility behave the same way.

STEPS TO REPRODUCE BEHAVIOR

  1. Make a change to MTA1.
2. UPDATE. 3. Make another change, but to MTA2. 4. UPDATE. 5. Go back to MTA1. 6. Changes made should be current, but notice that MTA1 has the original
   values.

  • or -

    1. Make a change to MTA1.
    2. UPDATE. 3. Make a change to MTA2. 4. UPDATE. 5. CANCEL (To exit). 6. Go back to REMOTE MTA screen and notice that the settings for MTA1
       and MTA2 do not reflect any changes you made.
    

  • Additional reference words: 3.20
    KBCategory: kb3rdparty
    KBSubcategory: MailGWX400


    THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

    Last reviewed: October 20, 1997
    © 1998 Microsoft Corporation. All rights reserved. Terms of Use.