X400: No Indentations in Routing Table Written by Config

Last reviewed: October 20, 1997
Article ID: Q115454

3.20 MS-DOS kb3rdparty

The information in this article applies to:

Microsoft Mail Gateway to X.400, version 3.2

The routing table written by the Config utility is not indented.

This may or may not strike you as important, but it might if you spend time manually typing in a routing table, then find that Config removes any indentation you inserted, even when you use Config to make only a small update.

Use X400ADM.EXE to work with the ROUTE.CFG file. The Admin utility prints the file with indentations and was designed as the tool for this type of job.

Additional reference words: 3.20
KBCategory: kb3rdparty
KBSubcategory: MailGWX400

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 20, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.