PC DynAd: DynaAdmin Does Not Recognize 50 Line Screen Mode

Last reviewed: October 31, 1994
Article ID: Q117805

The information in this article applies to:

Microsoft Mail for PC Networks, versions 3.0 and 3.2

SYMPTOMS

The DynAdmin application, included with versions 3.0 and 3.2 of Microsoft Mail for PC Networks, will not recognize 50 line screen mode and will only use the top 25 lines of the screen when attempting to do so.

STATUS

Microsoft has confirmed this to be a problem in versions 3.0 and 3.2 of Microsoft Mail for PC Networks. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.

MORE INFORMATION

DynAdmin is the administration program used to create dynamic drives and is commonly used to offset network server drive connection limitations or ensure that they are not exceeded.

Listed below are the available screen line modes catered to by MS-DOS:

   MODE 40,43
   MODE 40,50
   MODE 80,43
   MODE 80,50

DynAdmin will conform to each except for the 50 line screen mode and will typically position itself within the top 25 lines only.

Additional reference words: 3.00 3.20
KBCategory: kbtool
KBSubCategory: MailPCDynAd

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 31, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.