PC WRmt: Run w/ Megahertz EM114t Modem/Ethernet PCMCIA Card

The information in this article applies to:

• Microsoft Mail Remote for Windows, version 3.2

SUMMARY

When you run Microsoft Mail Remote for Windows with a Megahertz EM114t modem/ethernet PCMCIA card, you must either modify the CONFIG.SYS file to run the "card services" properly, or run the point enabler, SETEM.EXE, on the Megahertz Installation Diskette, if card & socket services are not installed on the computer.

If you do not make these changes or use the point enabler, the machine will produce error messages stating that the modem can not be found.

RESOLUTION

Procedure A: Modifying the Card Services Settings

The modifications to the "card services" in the CONFIG.SYS are:

   DEVICE=C:\EM\SSCIRRUS.EXE /ada=0 /skt=2
   DEVICE=C:\EM\CS.EXE /irq=b
   DEVICE=C:\EM\CSALLOC.EXE C:\CSALLOC.INI
   DEVICE=C:\EM\CARDID.EXE

Procedure B: Running the Point Enabler

The following switches can be used when you execute SETEM.EXE:

 Switch                  Description

 /sa or /sb              Socket placement (/sa=upper or /sb=lower)
 /c2                     COM port setting (/c2=com2)
 /i5                     Interrupt setting (/i5=interrupt 5)
 /bnnn                   Port or I/O Base for ethernet board
 /pnnnn                  Start of memory range exclusion for the card.
 /dnnnn                  Delay in milliseconds that the driver waits to
                         initialize the card.
 /m                      Modem only. This option disables the network
                         functions of the card.

CONFIG.SYS:

   DEVICE=C:\SETEM.EXE /sa /c2 /i5 /b300 /pd000

AUTOEXEC.BAT:

   SETEM.EXE /sa /c2 /i5 /b300 /pd000

• The examples above are the defaults mentioned in the Megahertz Ethernet-Modem "User Reference Guide".
• The point enabler will disable "hot swapping," or the ability to change PCMCIA cards without rebooting the computer.

MORE INFORMATION

For more information on configuring the Megahertz PCMCIA Ethernet-Modem card, EM1144-T, refer to Chapter Two - Installation of the Megahertz Ethernet-Modem "User Reference Guide," included with the EM1144-T PCMCIA card.

This information has been verified with Megahertz technical support.

Microsoft will support the use of the USGNERIC.SCR, with most Megahertz modems (PCMCIA or "pocket"), if configured properly, successful connections can be made at a maximum rate of 2400 baud.

On the Megahertz BBS and on the Megahertz library of the Modem Vendors forum of CompuServe,(GO MEGAHERTZ), the file MHSDRIVE.EXE should be downloaded. There are many scripts included in this file, the one that gives optimal performance is XJ144REL.SCR. T3144REL.SCR will also work well.