X400: How to Test X.25 Connection Before X.400 Installation

 Last reviewed: October 20, 1997
Article ID: Q86969
3.00 MS-DOS kb3rdparty

The information in this article applies to:

  • Microsoft Mail Gateway to X.400, version 3.0

To test the X.25 connection before installing the Microsoft Mail Gateway to X.400, perform these steps:

  1. NA TEST: To test the Eicon Card hardware parameters, jumper settings, and perform a complete set of hardware diagnostics on the Eicon card, use the NA TEST feature that comes with the Eicon card.

  2. Access software: The access software uses a protocol called ITI (Interactive Terminal Interface), which allows for the transfer of binary files between terminals across an X.25 network, for a test of file transfers and general X.25 network operation. Set up and perform this test before you install the X.400 gateway.

Additional reference words: 3.00 pcmail
KBCategory: kb3rdparty
KBSubcategory: MailGWX400

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 20, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.