X400: Typical Batch Files to Set Up and Start X.400 Gateway

Last reviewed: October 20, 1997
Article ID: Q86972
3.00 MS-DOS kb3rdparty

The information in this article applies to:

  • Microsoft Mail Gateway to X.400, version 3.0

The CONFIG.SYS files do not change when either the X.25 Eicon card or the redirector software is installed.

The AUTOEXEC.BAT files may contain the following startup:

   Server Startup
      nabios srv gateway /4
      ecload

Or, if the workstation is a redirector workstation:

   Eicon Redirector Software Startup
      nabios rdr gateway /4
      x25net start

A typical X.400 startup batch file appears as follows:

   x400gate -dq -lv

The Eicon X.25 card installation manual contains additional examples of installation and startup batch files.


Additional reference words: 3.00 pcmail
KBCategory: kb3rdparty
KBSubcategory: MailGWX400


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 20, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.