PROFS: How to Check VM Host for Enabled EXITs

 Last reviewed: October 20, 1997
Article ID: Q98339
3.10 3.20 3.30 MS-DOS kb3rdparty

The information in this article applies to:

  • Microsoft Mail Gateway to IBM PROFS and OfficeVision, versions 3.1, 3.2 and 3.3

The following statement can be used to allow the VM user to check the EXITs that are running on an MS-RSCS machine. This ensures that the EXITs used by Host Access are properly enabled: 

   SM ms-rscs_nodename Q SYS EXIT
The proper system response should be: 

   EXIT 2 enabled
   EXIT 15 enabled
The two exits are used by Host Access to set the To and From fields to show the proper send and recipient addresses.

Additional reference words: 3.10 3.20 3.30
KBCategory: kb3rdparty
KBSubcategory: MailGWPROFS

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 20, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.