PC DOS: Password Option with Micro Not Consistent

Last reviewed: October 27, 1994
Article ID: Q98783
The information in this article applies to:
  • Microsoft Mail for PC Networks, versions 3.0 and 3.2

SYMPTOMS

In versions 3.0 and 3.2 of Microsoft Mail for MS-DOS, running MICRO.EXE <user name> does not prompt you for a password as stated on page 83 of the Microsoft Mail "User's Guide" for MS-DOS.

RESOLUTION

To run Micro and be prompted for a password, type the following:

   MICRO <username> -p<password>

STATUS

Microsoft has confirmed this to be a problem in versions 3.0 and 3.2 of Microsoft Mail for MS-DOS. Microsoft is researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.


Additional reference words: 3.00 3.20 docerr
KBCategory: kbtool kbbug3.00 kbbug3.20
KBSubCategory: MailPCDOS


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 27, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.