SNA Server Setup Resets CA400 Settings in WNAP

Last reviewed: February 1, 1996
Article ID: Q134231

The information in this article applies to:

Microsoft SNA Server for Windows NT, version 2.11

SYMPTOMS

When you run SNA Client Win3x Setup after installing Client Access, you may lose Client Access Connectivity.

CAUSE

After you set up the SNA Client for CA400 support, the following line are in the [wnap] section of your WIN.INI:

   CA400=YES
   CA400SharedFolders=YES

When you re-run the SNA Client Setup to change a client value such as network protocol, Setup sets these entries back to their default value of "NO." This causes CA400 support to fail.

RESOLUTION

To correct this problem, open your WIN.INI file with a text editor, such as Notepad, and manually edit these entries back to "YES".

STATUS

Microsoft has confirmed this to be a problem in SNA Server for Windows NT. This problem was corrected in the latest SNA Server for Windows NT, 2.11 U.S. Service Pack. For information on obtaining the Service Pack, query on the following word in the Microsoft Knowledge Base (without the spaces):

   S E R V P A C K

KBCategory: kbnetwork kbsetup kbbug2.11
KBSubcategory: ntsetup
Additional reference words: 2.11 prodsna

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: February 1, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.