SNA Server Support for FNA and HNALast reviewed: April 17, 1997Article ID: Q139115 |
The information in this article applies to:
SUMMARYSNA Server version 2.11 supports the "Fujitsu Network Architecture" (FNA) and "Hitachi Network Architecture" (HNA) variants to IBM SNA. Support for these alternate SNA protocols is enabled adding the following registry keys:
HKEY_LOCAL_MACHINE/SYSTEM/CurrentControlSet/Services/SnaServr/Parameters
FNA_SUPPORT: REG_SZ: <value> (to enable FNA)
-or-
HNA_SUPPORT: REG_SZ: <value> (to enable HNA)
where <value> can be set to anything. The presence of this registry key
enables this support.
MORE INFORMATIONIf SNA Server is communicating to a host system which is running Fujitsu Network Architecture (FNA) protocol, the following sense code errors may occur if FNA_SUPPORT is not enabled:
80050001: No session: SNA Server received a request other than
session control request when no LU-LU session was active
If SNA Server is communicating to a host system which is running Hitachi
Network Architecture (HNA) protocol and HNA_SUPPORT is not enabled, an out-
of-chain CANCEL message sent to a type 3 Printer LU will be rejected by SNA
Server rather than being sent to the printer application.
|
Additional query words: prodsna
© 1998 Microsoft Corporation. All rights reserved. Terms of Use. |