Domain/Server Command Line Parameter Added to SNAADMINLast reviewed: July 18, 1996Article ID: Q141906 |
The information in this article applies to:
SUMMARYThe SNA Server Administration utility has been enhanced to allow you to specify the domain or server you wish to administer using a command line parameter.
MORE INFORMATIONA new command line parameter has been added to SNAADMIN.EXE to specify the subdomain or server to administer. The /NET: parameter has the following syntax:
SNAADMIN /NET:<name>where <name> is the name of a domain or server you wish to administer. Admin uses this domain or server name to connect with instead of the local domain. In previous versions, it was necessary to start SNA Server Admin at the local domain and then specify a "remote" domain using the Select Domain option from the File menu. No validation is done on the given name. If admin fails to connect, then the appropriate error message box is eventually shown. If the string "/NET:" is incorrectly typed, then the message "Configuration file not found" is displayed. This same message is also displayed for any other syntax error on the command line. The /NET:<name> parameter cannot coexist with the /OFFLINE argument or the filename parameter. In either of these cases, the /NET:<name> parameter is ignored, and Admin is started in offline mode. The /NET: parameter can coexist with /READONLY and /NO3D.
|
KBCategory: kbusage
© 1998 Microsoft Corporation. All rights reserved. Terms of Use. |