Maximum of Two DCA ISCA SDLC Adapters Allowed Per SNA Server

Last reviewed: April 17, 1997
Article ID: Q151393

The information in this article applies to:

Microsoft SNA Server for Windows NT, versions 2.0, 2.1, 2.11, 2.11 Service Pack 1, and 3.0

SYMPTOMS

When you install a third instance of the DCA SDLC Link Service on a SNA Server, you will get the following message:

   Setup Message

   The maximum of 2 DCA SDLC/X.25 boards are already configured.

CAUSE

The DCA SDLC Link Service for SNA Server has been written to allow a maximum of two DCA ISCA SDLC adapters per SNA Server.

Additional query words: prodsna
Keywords : kbnetserv kbnetwork kbsetup snasdlc
Version : 2.0 2.1 2.11 2.11.sp1 3.0
Platform : WINDOWS

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 17, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.