APPC Applications Fail to Connect to SNA Server 3.0 and 4.0

 Last reviewed: March 9, 1998
Article ID: Q166529
The information in this article applies to:
  • Microsoft SNA Server, version 3.0, 3.0 SP1, 3.0 SP2, 4.0

SYMPTOMS

APPC applications and 5250 emulators may appear to hang when trying to connect to a SNA Server, version 3.0 (including all SPs) or 4.0 system.

APPC applications and 5250 emulators may appear to hang when trying to connect to a SNA Server, version 3.0 or 3.0 Service Pack 1 (SP1) system.

After starting a 5250 session and entering an AS/400 Userid and Password in the AS/400 logon dialogue, the 5250 session will continue to display a blank screen and will not display the AS/400 signon screen. The session may eventually display an error similar to the following: 

   Could not connect to remote host.

   [0003][0000005]
This is the error that was displayed when using the 5250 Applet that is included with SNA Server when QPCSUPP was configured as the Implicit Incoming Mode in SNA Server Manager. It took several minutes before the error was displayed. The error message may be different depending on the emulator that is being used.

For other APPC applications, a SNA Server LU 6.2 Message trace may show that the SNA Server nevers responds to the "Open LU62 Request" that it receives from the APPC DLL on the client running the application.

CAUSE

This problem is caused if the Remote APPC LU defined in SNA Server 3.0 is configured to use an Implicit Incoming Mode that matches the APPC Mode that the application will be using. For example, the problem would occur if the Implicit Incoming Mode was set to APPCMODE and the APPC application was defined to use this mode.

The Implicit Incoming Mode is configured on the Options tab of the Remote APPC LU's property page in SNA Server Manager.

MORE INFORMATION

An Implicit Incoming Mode is used to define the properties to use when SNA Server receives a request to start an APPC session when an incoming APPC Allocate specifies a null Mode name or if the specified Mode name is not recognized by SNA Server.

WORKAROUND

The workaround is to change the Implicit Incoming Mode setting for Remote APPC LUs to either <None> or to a Mode name that the APPC/5250 applications are not actually using.

STATUS

Microsoft has confirmed this to be a problem in SNA Server version 3.0, 3.0 SP1, 3.0 SP2, and 4.0. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.

Additional query words: hang black
Keywords : prodsna sna5250 snaappc snacpic kbfix4.00.sp1 kbbuglist kbnetwork
Version : 3.0 3.0.sp1
Platform : winnt

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: March 9, 1998
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.