MMC Component Does Not Prompt for Restart After Installation

Last reviewed: March 19, 1998
Article ID: Q182707

The information in this article applies to:

Microsoft SNA Server, version 4.0

SYMPTOMS

The Microsoft Management Console (MMC) requires a restart when initially installed. However, SNA Server Setup does not inform the user that a restart is required. This can cause unpredictable results when you run the SNA Snap-in.

CAUSE

The MMC setup code does not set the restart flag during installation.

STATUS

Microsoft has confirmed this to be a problem in SNA Server version 4.0. We are currently researching this problem and will post more information here in the Microsoft Knowledge Base as it becomes available.

Keywords          : prodsna snasetup kbbug4.00 snammc
Version           : WINDOWS:4.0
Platform          : WINDOWS
Issue type        : kbbug
Solution Type     : kbfix

================================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: March 19, 1998
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.