PRB: "Directory Not Found" When Using Macintosh Client 4.00a

Last reviewed: June 2, 1997
Article ID: Q155438

The information in this article applies to:

Microsoft Visual SourceSafe for Macintosh, version 4.0a

SYMPTOMS

When users attempt to execute any command, a "Directory not found" message appears, and the command is not executed.

CAUSE

The server installation of SourceSafe is on the root of a server volume, such as <Volume>:

RESOLUTION

To correct this problem, move the server installation of Visual SourceSafe to a folder below the server volume, such as <Volume>:<Folder>:. Alternatively, you can change the folder level being shared to a higher level folder at the server.

STATUS

Microsoft is researching this behavior and will post new information here in the Microsoft Knowledge Base as it becomes available.

Keywords : ssafe kbprb kbtshoot
Version : 4.00a
Platform : MACINTOSH
Issue type : kbprb
Resolution Type : Info_Provided

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: June 2, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.