PRB: No Output from VxD Debug_Out and Trace_Out Macros

 Last reviewed: April 12, 1995
Article ID: Q76473
The information in this article applies to:
  • Microsoft Windows Device Driver Kit (DDK) for Windows versions 3.0 and 3.1

SYMPTOMS

In the Microsoft Windows graphical environment, when a virtual device (VxD) uses the Debug_Out and Trace_Out macros to obtain status information, no output is produced.

CAUSE

The debugging version of WIN386.EXE is not installed properly.

RESOLUTION

The Microsoft Knowledge Base contains instructions to properly install WIN386.EXE. This information can be found by querying on the following words: 

      prod(winddk) and win386.exe

Additional reference words: 3.00 3.10 DDKVXD debug devices virtual
wdeb386 win386
KBCategory: kbprg kbprb kbmacro
KBSubcategory: D3MiscWin386

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 12, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.