BUG: LineTo() Endcaps Misaligned with Large Pen Width

Last reviewed: January 5, 1995
Article ID: Q111576

The information in this article applies to:

Microsoft Windows Software Development Kit (SDK) for Windows versions 3.0 and 3.1

SYMPTOMS

If LineTo() is used with a wide pen selected, the endcaps are misaligned with the line; they are skewed at an angle relative to the line.

STATUS

Microsoft has confirmed this to be a bug in Windows version 3.0 and 3.1. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.

MORE INFORMATION

To reproduce the problem, select a black pen of width about 100:

   MoveTo(hDC,207,73)
   LineTo(hDC,512,251)

Look at the endcaps; they cause the line to appear twisted or deformed.

NOTE: To invalidate the area, the following was used:

   Rect.top=Y1-nCurPenWidth/2-1
   Rect.left=X1-nCurPenWidth/2-1
   Rect.bottom=Y2+nCurPenWidth/2+1
   Rect.right=X2+nCurPenWidth/2+1

If nCurPenWidth is greater than 103, then the endcaps are not completely erased, and fall outside the Rect area.

Additional reference words: buglist3.00 buglist3.10 3.00 3.10 end caps
KBCategory: kbprg kbbuglist
KBSubcategory: GdiDrw

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: January 5, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.