Files Modified by Workgroup Connections Setup Program

Last reviewed: November 21, 1994
Article ID: Q101173

The information in this article applies to:

Microsoft Workgroup Connections version 1.0

The Setup program for Microsoft Workgroup Connections version 1.0 modifies the CONFIG.SYS and AUTOEXEC.BAT files located at the root directory of the startup drive, regardless of where you are installing Workgroup Connections. This operation is by design.

Workgroup Connections 1.0 also creates SYSTEM.INI and PROTOCOL.INI files in the directory where you installed Workgroup Connections. If you mistakenly installed Workgroup Connections into your Windows for Workgroups directory, it modifies the SYSTEM.INI and PROTOCOL.INI files that are required for Windows for Workgroups. This may cause errors to occur when you run Windows for Workgroups.

KBCategory: kbnetwork kbsetup
KBSubcategory: wfwg wc wgao
Additional reference words: 3.10 connection remote diskless 1.0

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 21, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.