Err Msg with Adaptec 1542c: Cannot Write to Drive C:Last reviewed: November 22, 1994Article ID: Q103914 |
The information in this article applies to:
SYMPTOMSWhen you run Windows or Windows for Workgroups and use an Adaptec 1542c bus-mastering SCSI hard disk controller, you may receive the following error message:
Cannot write to drive C: CAUSEThe Adaptec 1542c controller does not need a device driver to function correctly in most circumstances. However, on some hardware, it cannot perform necessary functions (such as double buffering for direct memory access) without a device driver.
WORKAROUNDAccording to Adaptec Technical Support, a possible workaround is to use ASPI4DOS.SYS, which is normally used only with the 1542b SCSI controller. Load this driver in the CONFIG.SYS file as follows:
DEVICE=C:\DOS\ASPI4DOS.SYSThis line assists the controller in performing its functions.
MORE INFORMATIONYou can obtain ASPI4DOS.SYS from the Adaptec bulletin board service or Adaptec Technical Support. The Adaptec 1542c Controller is manufactured by Adaptec, a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.
|
KBCategory: kbhw kb3rdparty kberrmsg
© 1998 Microsoft Corporation. All rights reserved. Terms of Use. |