Standard Mode Video Grabber May be Deleted from WFWG 3.11

Last reviewed: November 21, 1994
Article ID: Q106233
The information in this article applies to:
  • Microsoft Windows for Workgroups version 3.11

Microsoft Windows for Workgroups version 3.11 does not support standard mode. However, the standard mode video grabber files from previous versions of Microsoft Windows or Windows for Workgroups may remain on the computer after version 3.11 is installed, as these files are not updated or deleted by Windows for Workgroups Setup.

To increase available disk space, you can delete the standard mode grabber files from your hard disk. Standard mode grabber files typically have an extension of .GR2 or .2GR and are located in the Windows SYSTEM subdirectory.

NOTE: The active enhanced mode video grabber file is identified in the "386Grabber=" line of the SYSTEM.INI file [Boot] section. This file must remain in the Windows SYSTEM subdirectory for Windows or Windows for Workgroups to function properly.


KBCategory: kbsetup kbdisplay kbgraphic
KBSubcategory: wfw wfwg
Additional reference words: 286Grabber 3.11


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 21, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.