WFWG 3.11 Err Msg: Executable Not Found

 Last reviewed: November 23, 1994
Article ID: Q107798
The information in this article applies to:
  • Microsoft Windows operating system versions 3.1, 3.11
  • Microsoft Windows for Workgroups versions 3.1, 3.11

SYMPTOMS

When you run Windows or Windows for Workgroups version 3.1 in standard mode or run Windows for Workgroups version 3.11 with the WIN.COM /D:T diagnostic switch, you receive the following error message: 

   Executable not found.

CAUSE

This error occurs if the WSWAP.EXE file is not located in the Windows SYSTEM subdirectory.

RESOLUTION

Use the EXPAND.EXE utility to expand a new copy of WSWAP.EXE from the original Windows or Windows for Workgroups disks. The WSWAP.EXE file is listed as WSWAP.EX_ on the following disks: 

Product                         3.5-inch 1.44 MB     5.25-inch 1.2 MB


Windows 3.1                           Disk 5                 Disk 5
Windows 3.11                          Disk 4                 Disk 5
Windows for Workgroups 3.1            Disk 6                 Disk 8
Windows for Workgroups 3.11           Disk 6                 Disk 7
For more information about using the EXPAND.EXE utility, type the following at an MS-DOS command prompt and then press ENTER: 

   expand /?

MORE INFORMATION

Windows for Workgroups 3.11 can be loaded without the 386 enhanced mode drivers by using the following command: 

   win /d:t
Loading Windows for Workgroups 3.11 with this command line can be helpful when you are troubleshooting issues associated with the 386 enhanced mode drivers.

When 386 enhanced mode drivers are not loaded, the WSWAP.EXE terminate-and- stay-resident (TSR) program is used to allow Windows to switch between MS-DOS-based applications and Windows. This file must be present when you load Windows with the command line shown above.

WSWAP.EXE is installed to the Windows SYSTEM subdirectory by the Windows Setup program and is always present unless it has been manually deleted from the hard disk.

KBCategory: kbenv kberrmsg
KBSubcategory: wfw wfwg win31
Additional reference words: 3.10 3.11 error DOSX.EXE hangs locks win /s

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 23, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.