WFWG 3.11 PIF Editor Has Standard Mode Command

Last reviewed: November 23, 1994
Article ID: Q107997

The information in this article applies to:

Windows for Workgroups version 3.11

SYMPTOMS

Windows for Workgroups 3.11 PIF Editor allows you to choose Standard Mode from the Mode menu. Windows for Workgroups 3.11 does not support standard mode.

CAUSE

This command remains in Windows for Workgroups 3.11 even though all standard-mode settings are ignored when the PIF file is used. If you choose Standard Mode, the following message is displayed:

   Windows is not running in standard mode.  The PIF information you
   enter may not be appropriate. Are you sure you want to switch to
   this mode?

If you choose OK, PIF Editor changes to the PIF editing screen for standard mode.

KBCategory: kbenv kbprb
KBSubcategory: wfw wfwg
Additional reference words: 3.11

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 23, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.