DFI 200h Mouse Settings Switch for Windows 3.0

Last reviewed: November 22, 1994
Article ID: Q66724
The information in this article applies to:
  • Microsoft Windows operating system versions 3.0, 3.0a

SYMPTOMS

You may have difficulty using the DFI 200H series mouse with Microsoft Windows version 3.0. For example, the mouse pointer may appear but not function, or the mouse pointer may be unavailable.

CAUSE

The switch on the mouse may be set up incorrectly.

RESOLUTION

The DFI 200H series mouse has a sliding button located on the side of the mouse. There are two settings that indicate the following:

   2 - for two-button mouse operation
   3 - for three-button mouse operation

Be sure that the switch is set for a two-button mouse.

To enable the mouse, you should place one of the following device statements in either the AUTOEXEC.BAT file or the CONFIG.SYS file.

NOTE: Do not use both statements at the same time. Use one or the other.

AUTOEXEC.BAT

   C:\DFIMOUSE\DFIMOUSE /Y

CONFIG.SYS

   DEVICE=C:\DFIMOUSE\DFIMOUSE.SYS


KBCategory: kbhw kb3rdparty
KBSubcategory: win30
Additional reference words: 3.00 3.0 3.0a 3.00a 3rdparty two three button
KBHW


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 22, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.