EGA.SYS Command Line Parameters MessageLast reviewed: November 23, 1994Article ID: Q67011 |
The information in this article applies to:
SUMMARYWhen the EGA.SYS device driver version 2.10.18 included with Microsoft Windows version 3.0 is loaded in CONFIG.SYS, it displays the following message on the screen as a default:
Command line parameters: FUNC=XX, to change INT 2FH function number. (where XX is 80 through FF hexadecimal inclusive)For example:
DEVICE=EGA.SYS FUNC=AC Using default value of BCH for interrupt 2FH function calls. A copy of the EGA Device Driver is being installed. MORE INFORMATIONThis message is no cause for alarm. The length of this message can be reduced by adding the FUNC=XX parameter on the end of the DEVICE=EGA.SYS line, where XX refers to the default value in the message on your computer screen. In the example message above, this modification would appear similar to the following:
DEVICE=EGA.SYS FUNC=BCOnce this change is made, the message on the screen reads as follows:
Using user defined value of BCH for interrupt 2FH function calls. |
KBCategory: kbother
© 1998 Microsoft Corporation. All rights reserved. Terms of Use. |