WIN.INI Run= Command Problem with Windowed MS-DOS Apps

Last reviewed: November 23, 1994
Article ID: Q67267

The information in this article applies to:

Microsoft Windows operating system versions 3.0, 3.0a

SYMPTOMS

When you use the Run= line in the WIN.INI file to start a windowed MS-DOS application followed by a Windows application, the keyboard input goes to the MS-DOS application. The focus remains on the MS-DOS application in the background and does not switch to the Windows application in the foreground as you would expect. This only happens in 386 enhanced mode.

The following is a sample WIN.INI run line:

   Run=word.pif winword.exe

WORKAROUND

To switch the focus to the Windows application in the foreground, click anywhere in the Windows application with the mouse. If you do not have a mouse, press ALT+ESC.

STATUS

Microsoft is researching this problem and will post new information here as it becomes available.

KBCategory: kbother
KBSubcategory: win30
Additional reference words: 3.00 win30 3.00a

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 23, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.