DCA IRMA Boards and E78PLUS Software with Windows 3.0

Last reviewed: November 23, 1994
Article ID: Q68803

The information in this article applies to:

Microsoft Windows operating system versions 3.0, 3.0a

SYMPTOMS

You may receive "insufficient memory error" messages when you run E78PLUS software with the DCA IRMA board in Microsoft Windows version 3.0 in enhanced mode. This problem does not occur with Windows' real or standard modes.

CAUSE

The E78PLUS software included with the IRMA board does not work in enhanced mode under Windows 3.0.

RESOLUTION

DCA suggests upgrading to its WindowLink program. WindowLink gives you the same 3278/79 terminal emulation, micro-to-mainframe file transfer capabilities, and other features as E78PLUS. WindowLink also supports DDE (dynamic data exchange).

MORE INFORMATION

Contact DCA technical support for more information.

The products included here are manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.

KBCategory: kb3rdparty
KBSubcategory: win30
Additional reference words: 3rdparty 3.00 3.0a 3.00a win30

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 23, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.