Zeos Machines Hang on Windows 3.0 Disk 2Last reviewed: November 22, 1994Article ID: Q70767 |
The information in this article applies to:
SUMMARYAccording to Zeos technical support, when you install Microsoft Windows 3.0 on most Zeos machines, you must configure the mouse for COM1 or Microsoft Windows Setup will hang when reading Windows Disk 2.
WorkaroundDuring Windows Setup, install for "No Mouse or other pointing device" and change it later, or install the mouse on COM1 before installing Windows 3.0.
MORE INFORMATIONAlso according to Zeos technical support, most Zeos machines have the ability to enable shadow RAM, but they are normally shipped with shadow RAM disabled. To determine the status of shadow RAM, run the CMOS Setup Utility by pressing CTRL+ALT+ESC immediately after bootup. The shadow RAM status will either be on the first screen (if it's AMI or Phoenix BIOS) or second screen (if it's Award BIOS [only on some newer SX models]). The products included here are manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.
|
KBCategory: kbhw
© 1998 Microsoft Corporation. All rights reserved. Terms of Use. |