Cannot Remove WinPopup from Load= Line in WIN.INI

 Last reviewed: November 21, 1994
Article ID: Q71502
The information in this article applies to:
  • Microsoft Windows operating system versions 3.0, 3.0a, 3.1, 3.11

SUMMARY

If you run Microsoft Windows configured for a Microsoft LAN Manager 2.0 or 2.1 enhanced (or 100% compatible) network, and the network is currently loaded with the NetPopup service active, you cannot start Windows without WinPopup being loaded.

If you remove WinPopup from the LOAD= line in the WIN.INI file, and you exit Windows and restart Windows while the NetPopup service is active, WinPopup is added back to the LOAD= line. This occurs because NetPopup determines that Windows is active and then checks to determine if WinPopup is there. If it WinPopup isn't already there, NetPopup adds it.

If you want to remove WinPopup, you must first prevent NetPopup from being automatically loaded. This article describes that procedure.

MORE INFORMATION

Preventing NetPopup From Loading Automatically

  1. Switch to the directory that contains the LANMAN.INI file. The default is C:\LANMAN.DOS.

  2. Make a backup copy of the LANMAN.INI file.

  3. Open LANMAN.INI with a text editor, such as Notepad.

  4. In the [workstation] section, find the following line: 

          WRKSERVICES=

  5. Remove NETPOPUP from the WRKSERVICES= line, and save the file.

  6. Restart the network.

  7. Open the WIN.INI file with a text editor, such as Notepad.

  8. Remove WinPopup from the LOAD= line, and save the file.

  9. Restart Windows and the WinPopup icon should not be present.

NOTE: Any messages received are not displayed but are written to the MESSAGES.LOG file that is in the LOGS subdirectory under the LANMAN.DOS directory and can be viewed using any text editor, such as Notepad.

Restarting NetPopup

After exiting Windows, if you desire to start the NetPopup service, type the following at the MS-DOS command prompt: 

   net start netpopup
NOTE: To end this service, you must restart the network. If you run NetPopup and then start Windows while this service is active, it adds WinPopup back in the LOAD= line.

The NET PAUSE NETPOPUP command does not work because message service is still active, although it does not send any messages through.

KBCategory: kbnetwork
KBSubcategory: win30 win31
Additional reference words: 3.0 3.00 win31 3.10 3.11 pop-up popup
net

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 21, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.