The information in this article applies to:
- Microsoft Windows operating system versions 3.0, 3.0a
SUMMARY
To install all of Microsoft Windows Resource Kit utilities, follow the
procedure in this article.
NOTE: You must install the Windows Resource Kit outside of Windows.
MORE INFORMATION
- Insert Windows Resource Kit disk 1 into your floppy disk drive.
- From the MS-DOS prompt, switch to your Windows directory; for example,
type
cd \windows
- Copy the KIT.BAT file from disk 1 to the Windows directory; for example,
type
copy kit.bat c:\windows
- To run KIT.BAT, specify your Windows directory, your source drive, and
your destination drive; for example, type:
kit c:\windows a: c:
- After the utilities are installed, the setup batch file installs the
Productivity Pack for Windows.
- After the Productivity Pack is installed, you can delete
the PPTMP subdirectory that has been created by the Productivity
Pack setup batch file.
The setup batch file installs these utilities into a WRKIT subdirectory
under the Windows directory. The program loads into the Windows
subdirectory, regardless of the drive and directory you specify as the
destination drive. For example, if you specify E: as the destination drive
the program loads into C:\WINDOWS.
Microsoft has confirmed this to be a problem in The Windows Resource Kit.
We are researching this problem and will post new information here as it
becomes available.
|