The information in this article applies to:
- Microsoft Windows operating system versions 3.0, 3.0a
SUMMARY
Windows may encounter some problems when running on a computer system
configured with an Intel 386 SnapIn. The following are some of the
most common situations:
- Windows returns to the command line after trying to load.
-or-
- The error message "Cannot file or load specific file" is received.
-or-
- Windows cannot be run in enhanced mode.
This information applies to Microsoft MS-DOS version 5.0 and Windows
versions 3.0 and 3.0a.
MORE INFORMATION
If Windows is having a problem operating on a system equipped with an
Intel SnapIn 386, check the following:
- Make sure Windows has been reinstalled after SnapIn 386 was added
to the system. This makes sure the 386 specific files necessary for
enhanced mode operation are copied to the hard drive. NOTE: This
case alone is the most common cause for the error message "Cannot
file or load specific file."
- Add VirtualHDIRQ=off to the 386ENH section of the SYSTEM.INI
file. This will enable certain hard disk controller interrupts to
go through the ROM routine that handles those interrupts, instead
of being controlled by Windows when running in enhanced mode.
- If SMARTDRV.SYS is loading, add the parameter /b+ to the end of the
SMARTDRV.SYS command line in the CONFIG.SYS file. The /b+ parameter
forces the double buffering capability of the SMARTDRV.SYS disk
cache to be installed. The line would look similar to the following
example:
DEVICE=[drive:][path]\SMARTDRV.SYS 1024 512 /B+
Warning: It is also possible to use the /b- parameter, which
disables the double buffering capabilities of SMARTDRV.SYS.
However, if there is a Bus Master board present in the system and
the /b- parameter is used, Data corruption may occur.
- Check for memory conflicts. If there are expansion boards in the
system that occupy memory address space (network boards, emulation
boards, and so on), add an EMMEXCLUDE= statement to the 386ENH
section of the SYSTEM.INI file. Exclude the range to cover the
memory address of the expansion board. The line would look similar
to the following example:
EMMEXCLUDE=A000-EFFF
NOTE: On an Intel SnapIn 386 equipped system running MS-DOS 5.0,
SMARTDRV.SYS looks at the system ID byte and sees a 286. It then
assumes that Windows cannot be run in enhanced mode. Because SnapIn
386 allows these systems to run in 386 enhanced mode, you must make
the adjustments above to ensure stable operation.
SnapIn 386 is manufactured by Intel, a vendor independent of
Microsoft; we make no warranty, implied or otherwise, regarding this
product's performance or reliability.
REFERENCES
Intel FaxBack Document #2770, #2850
For more information, query on the following words:
INTEL and BOARDS and COMPATIBILITY