Windows Err Msg: WDCTRL Cannot Load Due to ConflictLast reviewed: November 23, 1994Article ID: Q81803 |
The information in this article applies to:
SYMPTOMSYou receive the following error message when you start Windows or Windows for Workgroups:
WDCTRL cannot load due to conflict with another virtual deviceCAUSE This error message can occur when:
RESOLUTIONTo correct this problem, remove the WDCTRL line or add the line DEVICE=*INT13 to the [386Enh] section of the SYSTEM.INI file. If you are using MULTIS.386, either remove it from the SYSTEM.INI file, or remove both DEVICE=*INT13 and DEVICE=*WDCTRL. If you are using a third-party device driver for the hard disk drive controller, either remove the driver or remove DEVICE=*WDCTRL from the SYSTEM.INI file. NOTE: If a "Fastdisk validation error" occurs when you enter Windows after adding the DEVICE=*INT13 line to the SYSTEM.INI file, both the WDCTRL and the INT13 lines should be removed or commented out. (This error should occur only if you have manually edited the SYSTEM.INI file.)
|
KBCategory: kbenv kberrmsg
© 1998 Microsoft Corporation. All rights reserved. Terms of Use. |