On Target 1.0 Does Not Install on Windows System

Last reviewed: November 23, 1994
Article ID: Q82354

The information in this article applies to:

Microsoft Windows operating system versions 3.1, 3.11

SYMPTOMS

If you have the Microsoft Windows on your system, On Target version 1.0 does not install. After running On Target's installation program, your system is caught in an infinite loop. This usually occurs after about 10 percent of the installation is complete. An error message similar to the following is displayed:

   File error, can't find WIN310

You are then prompted to press a button, but the message continues to be displayed.

CAUSE

This is due to a problem in On Target version 1.0. Later versions do not have this problem.

RESOLUTION

You need to obtain a later version of On Target

MORE INFORMATION

The product included here is manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.

KBCategory: kb3rdparty
KBSubcategory: win31
Additional reference words: 3.10 ontarget 3.11

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 23, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.