EXP16.DOS Configures Intel EtherExpress 16 in WFWG

Last reviewed: November 21, 1994
Article ID: Q90203

The information in this article applies to:

Microsoft Windows for Workgroups versions 3.1, 3.11

When you change the adapter settings for the Intel EtherExpress 16 network adapter in Control Panel, changes are made only to the PROTOCOL.INI file-- they are not written to the card. When you restart your computer, the EXP16.DOS driver reads the PROTOCOL.INI file for configuration information. If the PROTOCOL.INI file has settings that are different from those on the card, the EXP16.DOS driver reconfigures the adapter before initializing it.

NOTE: If you are using two EtherExpress 16 cards in the same machine, you need to include the settings for both cards in the PROTOCOL.INI file and then run SoftSet to reconfigure the cards. This allows both cards to bind correctly when loading the protect mode (NDIS3) drivers.

KBCategory: kbnetwork kbhw kb3rdparty
KBSubcategory: wfw wfwg
Additional reference words: ether express 3.11 3.10 rebooting ethernet
3rdparty

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 21, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.