WFWG Setup Hangs If Cabletron E2000 Series Active

Last reviewed: November 21, 1994
Article ID: Q90206
The information in this article applies to:
  • Microsoft Windows for Workgroups version 3.1

SYMPTOMS

Windows for Workgroups Setup stops responding (hangs) immediately after displaying the initial blue screen if you are using a Cabletron E2000 series network adapter and the I/O address is anything other than 300.

This problem occurs when Setup attempts to perform network card detection. To work around this problem, run Setup /I to ignore hardware detection.

STATUS

Microsoft has confirmed this to be a problem in Windows for Workgroups version 3.1. We are researching this problem and will post new information here as it becomes available.


KBCategory: kbsetup kbbuglist kb3rdparty
KBSubcategory: wfw wfwg
Additional reference words: 3.10 hang hung stop stops stopped freeze
frozen 3rdparty


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 21, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.