The information in this article applies to:
- Microsoft Windows for Workgroups version 3.1
SUMMARY
Hardware conflicts are difficult to diagnose because they manifest
themselves in different ways depending on the type of network card and
what they are conflicting with (disk driver, sound board, and so on).
Typical hardware symptoms include:
- Failure of the network card device driver to load; Error 5733 when
the NET START command is used, or the network card fails to
bind.
- Inconsistent network behavior; the system stops responding (hangs)
sometimes, or errors occur copying large files over the network.
- Error 53: trying to connect to servers. (You cannot see anything on
the network.)
MORE INFORMATION
If you suspect some type of conflict, try one of the following:
- Switch the network card to a different interrupt.
- Check for memory conflicts between the network card and other
devices in the system. Some network cards use an area of upper
memory. If the area of memory, the card used is configurable. See
the documentation for the network card. You can determine which
parts of upper memory are being used by other devices by doing the
following:
1. Remove the network drivers and EMM386.EXE from CONFIG.SYS file.
2. Restart the computer.
3. Run Microsoft Diagnostics (MSD.EXE).
4. Look at the memory map.
It should show any upper memory being used. If the net card is
trying to use the same area as another device, reconfigure the
network card to use a different memory area.
- Make sure the memory range for the network card (if it uses one) is
excluded with EMM386.EXE if it is being used, or in the [386enh]
section of SYSTEM.INI file if EMM386.EXE in not being used.
|